How to Programme Multiple Blinds

Using Single Channel Handset(s)

These include: Single Channel Situo Pure Remote, Single Channel Telis 1 Remote, Single Channel Situo Variation Remote, Single Channel Telis 1 Chronis Timer Remote, and Single Channel Wall Switches (available in black & white colours).

You can programme your blinds all at the same time if they are all going onto one single channel remote control.

If each blind has its own separate remote, follow the instructions below:

1. Put all the blinds to sleep apart from the blind you are working on.
   • Temporary 15 minute sleep: Press & hold the button on the motor until it jogs once (about 3 seconds), briefly press the button again & the blind will jog 2 times. You can wake the blind up by briefly pressing the button on the motor and the blind will jog once.
   • Permanent sleep: Press & hold the button on the motor until it jogs once (about 3 seconds), then press all 3 buttons on the handset (UP, DOWN and MY) and the blind will jog again. You can wake the blind up by briefly pressing the button on the motor and the blind will jog once.
   • Programme the blind you are working on.
   • Put this blind to sleep & wake up another blind. Continue this for however many blinds you have ordered.

Using Multi Channel Handset

These include: Five Channel Situo 5 Remote, Five Channel Situo Variation Remote, Multi Channel Telis 16 Remote and the Six Channel Telis 6 Chronis Timer Remote. We also have the Connexoon & the TaHoma hubs available, which are multi channel home automation hubs.

Before you begin, remember to change to the correct channel on the remote control that you would like each blind to be programmed on.

1. Put all the blinds to sleep apart from the blind you are working on. Follow the same instructions as above.
2. Programme the blind you are working on.
3. Put this blind to sleep & wake up another blind. Continue this for however many blinds you have ordered.

If you have programmed one blind onto the wrong channel, simply select the correct channel and re-programme the blind. This will automatically delete the setting from the incorrect channel.

Copy & Paste Pre-Recorded Settings

If you have set up a blind and would like to duplicate the same settings to a different channel that can operate multiple blinds at the same time, rather than re-programming the same blind onto a different channel, you can copy & paste the settings.

1. Select the channel on the remote with the settings you would like to copy
2. Press & hold the programme button on the back of the remote control until the blind jogs once
3. Move to the channel that you would like to paste the settings to
4. Briefly press the programme button on the back of the remote & the blind will jog once
5. Done! It's as easy as that.